Performance And Application of 1070 Aluminum Sheet

1. Characteristics of 1070 Aluminum Sheet

1070 aluminum sheet is industrially produced pure aluminum with an aluminum content of 99.7%, also known as cathode aluminum sheet. Industrial pure aluminum has the general characteristics of aluminum, low relative density, good electrical conductivity, good heat transfer performance, good corrosion resistance, high plasticity, good heat transfer performance, good plasticity production and processing performance, and can be processed into sheets, strips, foils And extruded products, etc., can carry out gas cutting, argon arc welding machine, welding.

2. Physical Properties

Industrial production of pure aluminum cannot be strengthened by heat treatment, but the strength can be improved through cold deformation. Quenching is the only heat treatment method for cathode aluminum sheets.

3. Application Field

Cathode 1070 aluminum sheets are commonly used to produce parts with special properties, such as aluminum platinum gaskets and power capacitors, heat pipe radiators, charging piles, heat preservation projects, electronic equipment casings, rectifier protection nets, wires, and cables. Protective sleeves, nets, wire core wires, safety nets for cables, wire cores and aircraft exhaust system parts and decorative design parts. Make more use of its advantages to manufacture some parts with special properties, such as aircraft exhaust system parts and decorative design parts.

4. Performance Parameters.

Typical aluminum alloy: 1070 aluminum sheet

Raw materials: O, H12, H14, H16, H18, H19, H22, H24, H26, H28, H112, etc.

Thickness (mm): 0.1-500

Overall width (mm): 20-2650

Length (mm): 500-16000

5. Structural Mechanical Properties

Compressive strength σb (MPa): ≥55

Standard tensile strength σ0.2 (MPa): ≥15

Note: The mechanical properties of the vertical structure of the bar indoor temperature

Specimen specification: bar diameter (square rod, hexagonal rod inscribed circle diameter) ≤ 150

Condition: aluminum and aluminum alloy profile extruded bar (≤150mm, H112 state)